Headphone Mixes-COM 212

Headphone Mixes in COM 212A

There are Q 1 & 2 jacks in the 107 Recital Hall. Plug each Little Red Cue Box into either Cue 1 or 2 with the included 1/4" to XLR speaker-level cable. This is the ONLY cable that should be used with the LRCB. Make sure the volume on the LRCB is turned all the way down when not in use.

CUE 1

1. Cue 1 out of your DAW is normalized into Apollo X16 Line Output 15.
2. Apollo X16 Line Output 15 is normalized to the API Echo 1 Module.
3. Turn ON the Echo 1 module on the API.
4. Press the TB button on the Echo 1 module on the API. This assigns the Talkback mic to Echo 1.
5. Press the Ext. In button on the Echo 1 module on the API. This brings a mult from Apollo X16 Line Output 15 directly into the Echo 1 module.
6. Turn the Echo 1 pot to about 1 o'clock. This is the overall master volume level for both the API I/O echo trim pots and the cue faders in your DAW.
7. All Echo 1 sends on all API channels go to the Echo 1 module as well.
8. Use these individual Echo 1 trims to control the headphone volume of each LIVE instrument.
9. Make sure to press the PRE button on all the API echo sends on each channel. This allows you to control the headphone level separate from the faders!
10. Use the Cue faders in your DAW to control the volume of your previously recorded material.

CUE 2

1. Cue 2 out of your DAW is normalized into Apollo X16 Line Output 16.
2. Apollo X16 Line Output 16 is normalized to the API Echo 2 Module.
3. Turn ON the Echo 2 module on the API.
4. Press the TB button on the Echo 2 module on the API. This assigns the Talkback mic to Echo 2.
5. Press the Ext. In button on the Echo 2 module on the API. This brings a mult from Apollo X16 Line Output 16 directly into the Echo 2 module
6. Turn the Echo 2 pot to about 1 o'clock. This is the overall master volume level for both the API I/O echo trim pots and the cue faders in your DAW.
7. All Echo 2 sends on all API channels go to the Echo 1 module as well.
8. Use these individual Echo 2 trims to control the headphone volume of each LIVE instrument.
9. Make sure to press the PRE button on all the API echo sends on each channel. This allows you to control the headphone level separate from the faders!
10. Use the Cue faders in your DAW to control the volume of your previously recorded material.

212 Isolation Booth

The headphone distribution box must be connected in order to get a headphone mix in there.

1. Connect the headphone junction box to the 100 ft 1/4 cable.
2. Connect the other end of the 1/4 cable to either the CUE 1 or 2 input located on the AMP rack in 212 A.