Difference between revisions of "Audio Interface - Mixing Bench"
From Help Wiki
(Replaced content with "test Category:Audio Mixing Benches") |
(→Outputs) (Tag: VisualEditor) |
||
| (13 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | ||
| + | This lab has a '''Apollo x8''' audio Interface which has multiple inputs and outputs. | ||
| + | |||
| + | == Inputs == | ||
| + | * On the front there are two HI-Z inputs inputs (labelled '''HI-Z 1''' and '''HI-Z 2''') | ||
| + | ** Theses are for low level signal like electric guitars. Only use mono 1/4 cables. | ||
| + | * There are 4 XLR mic inputs on the back of the interface. | ||
| + | ** There is a panel with 4 XLR jacks below the interface. | ||
| + | ** These are connected to the 4 mic inputs. | ||
| + | ** Microphones can be connected to these inputs using XLR cables (not included in the room). | ||
| + | ** Each input has: | ||
| + | *** Trim control knob for setting input levels | ||
| + | *** Pad for reducing input levels | ||
| + | *** 48V Phantom Power for powering condenser microphones | ||
| + | *** Low cut filter. | ||
| + | * There are eight 1/4" line level inputs on the back. | ||
| + | ** Theses are not connected to anything | ||
| + | |||
| + | == Outputs == | ||
| + | * Outputs 1 and 2 are connected to the '''Mackie Big Knob''' monitor controller. | ||
| + | * The other outputs are not being used. | ||
| + | |||
| + | == Labeling == | ||
| + | * The various audio applications may refer to the inputs and outputs with slightly different names. | ||
| + | * We have tried to set the preferences to meaningful names but sometimes they may revert back to the default names. | ||
| + | * Read the [[Apollo x8 Interface]] article for additional information | ||
| + | |||
[[Category:Audio Mixing Benches]] | [[Category:Audio Mixing Benches]] | ||
Latest revision as of 10:16, 19 September 2023
This lab has a Apollo x8 audio Interface which has multiple inputs and outputs.
Inputs
- On the front there are two HI-Z inputs inputs (labelled HI-Z 1 and HI-Z 2)
- Theses are for low level signal like electric guitars. Only use mono 1/4 cables.
- There are 4 XLR mic inputs on the back of the interface.
- There is a panel with 4 XLR jacks below the interface.
- These are connected to the 4 mic inputs.
- Microphones can be connected to these inputs using XLR cables (not included in the room).
- Each input has:
- Trim control knob for setting input levels
- Pad for reducing input levels
- 48V Phantom Power for powering condenser microphones
- Low cut filter.
- There are eight 1/4" line level inputs on the back.
- Theses are not connected to anything
Outputs
- Outputs 1 and 2 are connected to the Mackie Big Knob monitor controller.
- The other outputs are not being used.
Labeling
- The various audio applications may refer to the inputs and outputs with slightly different names.
- We have tried to set the preferences to meaningful names but sometimes they may revert back to the default names.
- Read the Apollo x8 Interface article for additional information
