Difference between revisions of "Audio Lab Surround Sound Settings"
From Help Wiki
(→Assign the outputs of your DP tracks) |
(Tag: VisualEditor) |
||
| (17 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | __NOTOC__ | |
| − | # Power on O2R mixing console | + | ==Load the O2R surround sound scene== |
| − | # Scene Memory > | + | # Power on O2R mixing console (Tripp Lite main power bar located on the right side of desk) |
| + | # On the O2R find Scene Memory > Use the up or down arrow buttons to find "03 surround mix" > Press Recall | ||
# this assigns the inputs 25 - 30 to bus 1 - 6 (omni outputs to surround sound) | # this assigns the inputs 25 - 30 to bus 1 - 6 (omni outputs to surround sound) | ||
| + | # In the "LAYER" section, press 25-48 button, faders 25 - 31 should be up to unity 0, this recieves audio from the MOTU sound cards via Digital Performer | ||
| + | # In the "LAYER" section, press the MASTER button, ALL BUS faders should be up to unity 0, these outputs go to the Surround Monitor Controller | ||
# pan is disabled in the routing page | # pan is disabled in the routing page | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
===SPL surround controller=== | ===SPL surround controller=== | ||
| − | # | + | # Select A surround |
| − | # | + | # Press the 6 X 5.1 surround monitor push buttons |
| − | # | + | # Turn on Adam speakers |
| − | # | + | # Turn up volume |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | [[Category:Audio | + | [[Category:Audio Lab]] |
Latest revision as of 18:01, 18 February 2026
Load the O2R surround sound scene
- Power on O2R mixing console (Tripp Lite main power bar located on the right side of desk)
- On the O2R find Scene Memory > Use the up or down arrow buttons to find "03 surround mix" > Press Recall
- this assigns the inputs 25 - 30 to bus 1 - 6 (omni outputs to surround sound)
- In the "LAYER" section, press 25-48 button, faders 25 - 31 should be up to unity 0, this recieves audio from the MOTU sound cards via Digital Performer
- In the "LAYER" section, press the MASTER button, ALL BUS faders should be up to unity 0, these outputs go to the Surround Monitor Controller
- pan is disabled in the routing page
SPL surround controller
- Select A surround
- Press the 6 X 5.1 surround monitor push buttons
- Turn on Adam speakers
- Turn up volume
