Difference between revisions of "3D Printers"

Revision as of 10:09, 16 February 2017

Intro

• For the 2016-2017 the 3D printers have been set up in the Library building L1523.
• On the first floor on the Library building walk past the Multimedia Lab and take a left at the garbage/recycling area. There is a sign labeled "24-Hour Suites".

• For more information contact Aaron Kruse, 360-867-6842 L1507.

Scheduling

• The 3D Printer room is scheduled at Media Loan or the Multimedia Lab.
• Media Loan is located at Library 2504 or you can call 360-867-6253.
• The room is available 24 hours seven days a week but you need to schedule time and checkout the key while Media Loan is open.
• Here is the scheduling policy.
• There are late fees for over due keys so return the keys on time.
• If you schedule time when the building is closed Media Loan will give you an extra key FOB to open the Library Building exterior door.

Equipment

Makerbot Replicator 2

• There is one Makerbot Replicator 2 printer in the one.
  • Load you files onto the printer with the SD cards.
• There is one Lulzbot Mini printer which is connected to a computer.

Lulzbot Mini

• There is one Lulzbot Mini.
• Load files to it with the Cura application on the computer to the right of the printer.

The Other Printer

• There is a red 3D printer
• Only use if you have been instructed how it works.

Computer

• Use Cura with the Lulzbot.
• The Makerbot software is installed if you need to convert files.
• There is a memory card reader for loading files on to SD cards.

Notes

• It OK to prop the door open while printing is you are in the room or in the hallway.
• If you leave the area while printing make sure to close the door.
  • Do not leave for more than 15 minutes. The printers can jam and stop printing.