Difference between revisions of "16mm Transfer Station"
From Help Wiki
| Line 15: | Line 15: | ||
# In '''StCamSWare''' go to '''Option''' > '''Settings''' and a new window will open. | # In '''StCamSWare''' go to '''Option''' > '''Settings''' and a new window will open. | ||
# Click the '''Advanced''' button in the bottom right. If the bottom right button is "Simple" than you are already in the '''Advanced''' window. | # Click the '''Advanced''' button in the bottom right. If the bottom right button is "Simple" than you are already in the '''Advanced''' window. | ||
| + | # Go to the '''Trigger''' tab and configure the following settings. | ||
| + | #* Operation Mode : Trigger | ||
| + | #* Trigger Source : Hardware | ||
| + | #* Trigger Mode : Edge Preset | ||
| + | # Go to the '''IO''' tab and configure the following settings. | ||
| + | #* I00 : Trigger Input [10] | ||
| + | #* Polarity : Negative | ||
| + | #* Trigger Mode : Edge Preset | ||
[[Category:Multimedia Lab]] | [[Category:Multimedia Lab]] | ||
Revision as of 16:10, 7 February 2014
Contents
Getting Ready
Power
- Turn on power strip
- Start the computer
- Turn on the projector (Back right)
- Log into computer
Cleaning
- Open StCamSWare from the desktop
- Turn projector to Still to turn on the light.
- Look at StCamSWare and if the image is dirty you need to clean the projector.
- Pull the light away from the projector and clean with canned air.
Settings
- In StCamSWare go to Option > Settings and a new window will open.
- Click the Advanced button in the bottom right. If the bottom right button is "Simple" than you are already in the Advanced window.
- Go to the Trigger tab and configure the following settings.
- Operation Mode : Trigger
- Trigger Source : Hardware
- Trigger Mode : Edge Preset
- Go to the IO tab and configure the following settings.
- I00 : Trigger Input [10]
- Polarity : Negative
- Trigger Mode : Edge Preset
