Difference between revisions of "O2R-MOTU-Digital Performer Cheat Sheet"

Revision as of 13:15, 16 July 2018

Directions:

Locate scene memory Press Display Toggle to Scene 95 or 96 Press Recall

(Mic panels in 1362 are normalized to the inputs of O2R MIC/LINE inputs)

O2R - find Layer section and select 1-24
Trim out or choose +48V On/Off for each channel you plugged in to
Push fader up and you should see levels on the Meters
Push up stereo fader
On the Control Room section select STEREO
Turn up Control Room Level light grey knob to control speaker volume
Open Digital Performer and choose Audio Lab Template, save to Storage drive in your folder with your name on it.
On Layer 25-48 of the O2R, channels 25 & 26 are the MAIN L/R OUT of Digital Performer

Headphone Mixes

Use the Encoder knobs on the O2R to control headphone volume
In the Encoder Mode section select AUX
Use the Encoder knob on your LIVE channel to control volume to the headphones
Use the Encoder knob on channels 25 & 26 to control volume from Digital Performer Mix L Mix R

@@ Line 1: / Line 1: @@
+== '''At a Glance''' ==
 '''Directions:'''
-*Turn ON Main Power (orange switch on desk to the right)
 *On the O2R console:
 	Locate scene memory
 	Press '''Display'''
-	Toggle to '''95 Zena DP template'''
+	Toggle to Scene '''95 or 96'''
 	Press '''Recall'''
+** 	Scene 95 if for Multitrack Recording, Scene 96 is for Surround Mixing.
 *Studio: Patch in microphone to Panel A, Input 1
@@ Line 26: / Line 26: @@
 *Use the Encoder knob on your '''LIVE''' channel to control volume to the headphones
 *Use the Encoder knob on channels 25 & 26 to control volume from Digital Performer Mix L Mix R
 [[Category:Audio Lab]]