Difference between revisions of "Apollo x8 Interface"

Revision as of 15:27, 15 September 2023

We have Apollo x8 interfaces installed in the four Music Tech Labs, both Audio Mixing Benches and the 5.1 room.

Intro

• We have Apollo x8 interfaces installed in the four Music Tech Labs, both Audio Mixing Benches and the 5.1 room.
• The are multichannel interfaces with
  • HI-Z inputs for guitars
  • Mic inputs with XLR jacks
  • Line inputs with 1/4" jacks
• The interfaces and software were configured to work in the various labs.
• The Music Tech labs make use of more inputs and outputs of the interface.
• The Audio Music Benches are set up in a similar way to make moving between labs easier.
• Not all of the inputs and outputs are connected in the various labs.

Inputs

• On the front there are two HI-Z inputs inputs (labelled HI-Z 1 and HI-Z 2)
  • Theses are for low level signal like electric guitars.  Only use mono 1/4 cables.
• There are 4 XLR mic inputs on the back of the interface.
  • There is a panel with 4 XLR jacks below the interface.
  • These are connected to the 4 mic inputs.
  • Microphones can be connected to these inputs using XLR cables (not included in the room).
  • Each input has:
    • Trim control knob for setting input levels
    • Pad for reducing input levels
    • 48V Phantom Power for powering condenser microphones
    • Low cut filter.
• There are eight 1/4" line level inputs on the back.

Selecting Inputs

• Press the Preamp knob to toggle between inputs 1-4.
• The number over the corresponding input on the LED display will light up.
• Press the INPUT button to toggle between MIC and LINE for the current input.
• Connecting a cable to HI-Z 1 or HI-Z 2 will force the inout switch to HI-Z

Input Controls for Inputs 1-4

• Input: toggles between MIC and LINE for the current input.
• Low Cut Filter: Enables a filter with a cutoff frequency of 75 Hz with a slope of 12 dB per octave.
  • Affects Mic, Line and HI-Z inputs
• +48V: Press to turn on phantom power.
  • When pressed the light will flash red.
  • When the red light is solid phantom power is enabled.
  • Only use with condenser mics.
• Pad: When enabled, the channel’s XLR Mic input signal level is attenuated by 20 dB.
  • Does not effect the Line or Hi-Z inputs.
• Polarity: Inverts the phase of the input by 180 degrees.
  • Leave off
• Link: Links the preamp controls of adjacent preamp channels together.
  • 1 and 2 and 3 and 4
  • Only the same types of inputs can be linked.
    • Mic/Mic or Line/Line
    • Does not work HI-Z inputs

Outputs

• There are 8 line outputs on the back.
• Not every lab is using all 8 outputs.

Labeling

• The various audio applications may refer to the inputs and outputs with slightly different names.
• We have tried to set the preferences to meaningful names but sometimes they may revert back to the default names.  
• Below are table with the list of the inputs and outputs  
• Some are physical inputs and outputs and others and virtual connections from the UA Console app.  

Inputs

Outputs