Audio Lab Surround Sound Settings

Load the O2R surround sound scene

1. Power on O2R mixing console (Tripp Lite main power bar located on the right side of desk)
2. On the O2R find Scene Memory > Use the up or down arrow buttons to find "03 surround mix" > Press Recall
3. this assigns the inputs 25 - 30 to bus 1 - 6 (omni outputs to surround sound)
4. In the "LAYER" section, press 25-48 button, faders 25 - 31 should be up to unity 0, this recieves audio from the MOTU sound cards via Digital Performer
5. In the "LAYER" section, press the MASTER button, ALL BUS faders should be up to unity 0, these outputs go to the Surround Monitor Controller
6. pan is disabled in the routing page

SPL surround controller

1. Select A surround
2. Press the 6 X 5.1 surround monitor push buttons
3. Turn on Adam speakers
4. Turn up volume