Difference between revisions of "16mm Transfer Station"

Revision as of 17:25, 7 February 2014

Getting Ready

Power

1. Turn on power strip
2. Start the computer
3. Turn on the projector (Back right)
4. Log into computer

Cleaning

1. Open StCamSWare from the desktop
2. Turn projector to Still to turn on the light.
3. Look at StCamSWare and if the image is dirty you need to clean the projector.
4. Pull the light away from the projector and clean with canned air.

Settings

1. In StCamSWare go to Option > Settings and a new window will open.
2. Click the Advanced button in the bottom right. If the bottom right button is "Simple" than you are already in the Advanced window.
3. Go to the Trigger tab and configure the following settings.
   • Operation Mode : Trigger
   • Trigger Source : Hardware
   • Trigger Mode : Edge Preset
4. Go to the IO tab and configure the following settings.
   • I00 : Trigger Input [10]
   • Polarity : Negative
   • Trigger Mode : Edge Preset

Threading the Projector

1. Make sure that you have 4ft of leader to the heads and tail of the film.
2. Push the autoloader
3. Trim the film if needed.
4. Put the film on the supply reel arm.
5. Set projector to Forward and insert the film.
6. When there is enough film to thread turn off the projector and thread onto the take up reel.
7. Pull the film to make sure the autoloader is off.