Difference between revisions of "Rotoscope Station"
From Help Wiki
(→Rotoscoping Stations) |
(→Rotoscoping Stations) |
||
| Line 4: | Line 4: | ||
**2D Roto Lab, Library 1408 which also has a capture stand. | **2D Roto Lab, Library 1408 which also has a capture stand. | ||
**Com Rotscope Lab , Com 310A, which is only for rotoscoping. | **Com Rotscope Lab , Com 310A, which is only for rotoscoping. | ||
| − | + | ===Rotoscope Rules=== | |
| − | + | * Never: | |
| − | ** | + | ** use liquids or messy materials on the table. |
| − | + | ** kick the projector | |
| − | + | ** touch the glass lens | |
| + | ** change projector menu settings | ||
| + | ** unplug anything | ||
| + | |||
| + | * Always: | ||
| + | ** power up and shut down projector properly | ||
| + | ** double-check projector screen dimensions and focus | ||
| + | ** create a guide frame | ||
| + | ===Using the Rotoscope=== | ||
** Log into the log book and note that you used the rotoscope section | ** Log into the log book and note that you used the rotoscope section | ||
** Turn on the main power switch on the desk, fire up the computer, and press the projector power switch. The projector will take a few moments to warm up. | ** Turn on the main power switch on the desk, fire up the computer, and press the projector power switch. The projector will take a few moments to warm up. | ||
Revision as of 11:07, 21 April 2015
Rotoscoping Stations
- There are two rotoscoping stations.
- 2D Roto Lab, Library 1408 which also has a capture stand.
- Com Rotscope Lab , Com 310A, which is only for rotoscoping.
Rotoscope Rules
- Never:
- use liquids or messy materials on the table.
- kick the projector
- touch the glass lens
- change projector menu settings
- unplug anything
- Always:
- power up and shut down projector properly
- double-check projector screen dimensions and focus
- create a guide frame
Using the Rotoscope
- Log into the log book and note that you used the rotoscope section
- Turn on the main power switch on the desk, fire up the computer, and press the projector power switch. The projector will take a few moments to warm up.
- The data projector is recognized as a third monitor on the left-most side. TO be able to see what you are doing, move the keyboard over to the rotoscope stand and bring the mouse cursor over to the far left.
- Confirm the resolution of the data projector image is set to 1024x768 60 Hz by going to System Preferences > Display Settings > Display 3
- Open your footage in iMovie, Final Cut, or Quicktime and position the video monitor so that it is displayed on the rotoscope station with the desired dimensions.
- On the projector, adjust the zoom and the focus on the edges of the lense. Note: the zoom is adjusted by twisting the lens closer toi the projector body, and the focus is adjusted by twisting the outermost ring.
- Adjust the positioning of the animation registration board on the table.
- Create a guide frame using a piece of paper to line up your artwork at a later time.
- Start rotoscoping! Use the left and right arrow keys to navigate through each frame.
- When finished, shut down the projector by pressing the power button until the display is black . The fan inside the projector will run for a while to allow the lamp to cool down.
- Bring the mouse cursor over to the far right screen. Shut down the computer and turn off the main power switch on the desk.
- Cap the projector lens
- Record any problems in the log book.
- Video footage that is displayed on the left-hand computer monitor is projected up onto the drawing surface of the stand.
