Start Up Procedure/Proficiency - COM 118

From Help Wiki
Revision as of 15:12, 19 October 2015 by Jonsam12 (Talk | contribs) (SHUT DOWN PROCEDURES)

START UP PROCEDURES

  1. Log into the logbook
  2. Explain the simple room flow
  3. Explain the norms from the NEVE to the Apollos
  4. Use the LG Display Remote to turn on Display monitors
  5. Turn ON and login to the computer
  6. Turn ON the two Power Bars. One below the Apollos, and the other on the rack
  7. Power ON Apollo A Interface (wait to load: HOST, INT, 48)
  8. Power ON Apollo B interface (wait to load: HOST, EXT, 48)
  9. Make a new folder with your name on it in the Storage drive

SIGNAL FLOW

  1. Go through the signal flow of an input channel
  2. Explain when you would put the channel in TAPE
  3. Patch a source into an input channel of the NEVE
  4. Explain the channel Cue function and master Cue section of the NEVE
  5. Turn the Cue send 1 and 2 up on the channel, and monitor the Cue send volume
  6. Open Digital Performer
  7. Select - New - 118 Multitrack Template
  8. Record the source that's on the NEVE
  9. Explain the Cue function in DP and where the Cue sends go on the NEVE
  10. Monitor and adjust the Cue send level in DP and on the NEVE
  11. Patch the recorded channel into the Portico module (Channel 6)

MONITORING SECTION

  1. Run iTunes
  2. Select "Apollo A Monitor Out Ext. 1" On NEVE console Control Room monitor select

SHUT DOWN PROCEDURES

  1. Normalize board
  2. Turn OFF both Apollos
  3. Clear patchbay, turn off the two power switches and the Display monitors
  4. Logout