Difference between revisions of "Start Up Procedure/Proficiency - COM 118"

Revision as of 14:06, 19 October 2015

START UP PROCEDURES

1. Log into the logbook
2. Explain the simple room flow
3. Explain the norms from the NEVE to the Apollos
4. Use the LG Display Remote to turn on Display monitors
5. Turn ON and login to the computer
6. Turn ON the two Power Bars below the Apollos and on the rack
7. Power ON Apollo A Interface (wait to load: HOST, INT, 48)
8. Power ON Apollo B interface (wait to load: HOST, EXT, 48)
9. Make new folder with your name in the Storage drive

1. Go through the signal flow of an input channel
2. Explain when you would put the channel in TAPE
3. Patch a source into an input channel of the NEVE
4. Explain the channel Cue function and master Cue section of the NEVE
5. Turn the Cue send 1 and 2 up on the channel, and monitor the Cue send volume
6. Open Digital Performer
7. Select - New - 118 Multitrack Template
8. Record the source that's on the NEVE
9. Explain the Cue function in DP and where the Cue sends go on the NEVE
10. Monitor and adjust the Cue send level in DP and on the NEVE
11. Patch the recorded channel into the Portico module (Channel 6)

1. Run ITunes
2. Select "Apollo A Monitor Out Ext. 1" On NEVE console Control Room monitor select

1. Normalize board
2. Shutdown studio
3. Logout