Difference between revisions of "Start Up Procedure/Proficiency - COM 118"
From Help Wiki
(→START UP PROCEDURES) |
(→START UP PROCEDURES) |
||
| Line 9: | Line 9: | ||
#Power ON Apollo B interface (wait to load: HOST, EXT, 48) | #Power ON Apollo B interface (wait to load: HOST, EXT, 48) | ||
#Make new folder with your name in the Storage drive | #Make new folder with your name in the Storage drive | ||
| − | + | ===SIGNAL FLOW=== | |
#Go through the signal flow of an input channel | #Go through the signal flow of an input channel | ||
#Explain when you would put the channel in TAPE | #Explain when you would put the channel in TAPE | ||
| Line 21: | Line 21: | ||
#Monitor and adjust the Cue send level in DP and on the NEVE | #Monitor and adjust the Cue send level in DP and on the NEVE | ||
#Patch the recorded channel into the Portico module (Channel 6) | #Patch the recorded channel into the Portico module (Channel 6) | ||
| − | + | ===MONITORING SECTION=== | |
| − | #Run | + | #Run iTunes |
#Select "Apollo A Monitor Out Ext. 1" On NEVE console Control Room monitor select | #Select "Apollo A Monitor Out Ext. 1" On NEVE console Control Room monitor select | ||
| − | + | ===SHUT DOWN PROCEDURES=== | |
#Normalize board | #Normalize board | ||
| − | # | + | #Clear patchbay, turn off the two power switches, turn off TV |
#Logout | #Logout | ||
[[Category:COM 118]] | [[Category:COM 118]] | ||
Revision as of 14:09, 19 October 2015
START UP PROCEDURES
- Log into the logbook
- Explain the simple room flow
- Explain the norms from the NEVE to the Apollos
- Use the LG Display Remote to turn on Display monitors
- Turn ON and login to the computer
- Turn ON the two Power Bars below the Apollos and on the rack
- Power ON Apollo A Interface (wait to load: HOST, INT, 48)
- Power ON Apollo B interface (wait to load: HOST, EXT, 48)
- Make new folder with your name in the Storage drive
SIGNAL FLOW
- Go through the signal flow of an input channel
- Explain when you would put the channel in TAPE
- Patch a source into an input channel of the NEVE
- Explain the channel Cue function and master Cue section of the NEVE
- Turn the Cue send 1 and 2 up on the channel, and monitor the Cue send volume
- Open Digital Performer
- Select - New - 118 Multitrack Template
- Record the source that's on the NEVE
- Explain the Cue function in DP and where the Cue sends go on the NEVE
- Monitor and adjust the Cue send level in DP and on the NEVE
- Patch the recorded channel into the Portico module (Channel 6)
MONITORING SECTION
- Run iTunes
- Select "Apollo A Monitor Out Ext. 1" On NEVE console Control Room monitor select
SHUT DOWN PROCEDURES
- Normalize board
- Clear patchbay, turn off the two power switches, turn off TV
- Logout
